Premnagar Dehradun Uttrakhand India

Wireless AVR Development Board

Wireless AVR Development Board

Wireless AVR Development Board


Wireless AVR Interfacing board (ATMEGA16/32) is made from single sided PTH PCB board to provide extra strength to the connector joints for increased reliability. Board can work on 12V DC supply & provides 3.3V, 5V & 12V output. It has built-in reverse polarity protection. 7805 voltage regulator has heat sink for heat dissipation so that it can supply 1Amp current continuously without getting over heated. It has switches reset and power. It also has RS232 interface with DB9 female connector based on MAX232. Its having onboard inbuilt XBee direct interfacing with MCU, RFID Reader interfacing,  temperature Sensor (LM35), ADC Variable register, 8 input push buttons, Relay, Speaker, LCD interface, 2 dimmer 16 level, Motor driver (L293D), 7Seg, 8 led interfacing with AC pins load input & outputs. All the ports are connected to standard 10 pin FRC connectors. Open pads for connecting microcontroller’s pins to external devices are also provided.


  • Microcontroller: ATMEGA16 with 11.0592 MHz crystal (Also compatible for ATMEGA32)
  • Single side high quality PTH PCB for added strength.
  • RS232 serial interface
  • XBee inbuilt Interface
  • RFID Reader inbuilt Interface
  • Built in Zigbee interface connector (USART/UART)- GND, Vcc, Rx, Tx
  • 7seg inbuilt Interface
  • Motor driver L293D inbuilt Interface
  • 2 Dimmer 16 level inbuilt Interface
  • 8 LED inbuilt Interface
  • Inbuilt ISP programming connector, can program by any programmer
  • Power: Input 12V DC, Heat sink on 7805 for better current rating, output- 3.3V, 5V, 12V DC with FRC connectors
  • Reverse polarity protected
  • Switches: Reset, Power, input port push button switch-8
  • 10 pin FRC connectors and soldering pads on all ports
  • Compatible with General purpose prototyping board for development board for stackable design

ATMEGA16 Microcontroller Features

  • Advanced RISC Architecture
  • Up to 16 MIPS Throughput at 11.0592 MHz
  • 16K Bytes of In-System Self-Programmable Flash
  • 512 Bytes EEPROM
  • 1K Byte Internal SRAM
  • 32 Programmable I/O Lines
  • In-System Programming by On-chip Boot Program
  • 8-channel, 10-bit ADC
  • 8 Single-ended Channels
  • 2 Differential Channels with Programmable Gain at 1x, 10x, or 200x
  • Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes
  • One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture
  • Real Time Counter with Separate Oscillator
  • Four PWM Channels
  • Programmable Serial USART
  • Master/Slave SPI Serial Interface
  • Byte-oriented Two-wire Serial Interface
  • Programmable Watchdog Timer with Separate On-chip Oscillator
  • External and Internal Interrupt Sources
  • 40-pin PDIP package

Package contains

  • ATMEGA16 Development Board (With ATMEGA 16 Microcontroller)
  • PDF file link
  • Support
  • AVR Studio download link
  • Embedded C Library link

For any queries, Please write to us..

[contact-form-7 id=”72″ title=”Contact form 1″]

WhatsApp chat