Sensor intelligence
Reads level continuously and decides when to stop — and on the Auto models, when to start.
Home
About SME
Products
Solutions
Case Studies
Blog
Embedded Books
Contact Us
Request Quote
+91 99277 15123
info@smedehradun.com
Water tank automation
A controller that reads your tank without a float switch, runs the pump only when it should, and cuts power the moment the source runs dry. Three models, one decision: how much you want it to do for you.
Designed and built in Dehradun
How it works
Float switches jam, corrode and stick. myTankLinker works out the level from the tank itself and decides what the pump should do — so there is nothing mechanical inside the tank to fail, and nothing extra to buy.
Reads level continuously and decides when to stop — and on the Auto models, when to start.
Nothing mechanical sits in the water, so nothing sticks or corrodes.
EEPROM holds your configuration through power cuts. Nothing to redo.
Standard mono-block and Tullu pumps up to 2 HP. No adapter needed.
Wires into your existing switchboard. No plumbing changes.
Take control by hand at any time, on every model.
No add-on sensors, probes or modules. The box is the whole system.
Designed around intermittent municipal water and unstable voltage.
Three models
Every model watches the level the same way. What changes is whether it switches the pump for you, and whether it also watches the underground tank.
One tank · you switch
Shows you the level and stops the pump when the tank is full. Starting it is up to you.
One tank · hands off
Starts and stops the pump on its own, and cuts power if the pump starts running dry.
Two tanks · hands off
Watches the underground tank as well, so the pump never starts against an empty sump.
Side by side
| Feature | Manual | Auto | Auto + UG |
|---|---|---|---|
| Overhead tank support | |||
| Underground tank support | |||
| Automatic start and stop | Stop only | ||
| Dry run protection | Via UG sensing | ||
| Manual pump control | |||
| Sensor intelligence | |||
| Float-free design | |||
| LED indicators | |||
| EEPROM memory backup | |||
| DIY installation | |||
| Extra sensors needed | None | None | None |
Where it fits
Refills happen without anyone remembering to switch on.
Removes a daily job from the front desk and the caretaker.
Stops overflow at night and dry running in the morning rush.
Keeps supply steady through the working day without checks.
Nobody has to climb to the terrace to look inside a tank.
Handles community systems where no one person is in charge.
Fewer tenant calls about water, and less of it wasted.
Hard water and silt do not stop it, because nothing moves.
Choose yours
Not sure which one fits your setup?
Tell us how your tanks are arranged and we will tell you which model to buy.